FAA Approved Repair Station BA3R390L
FAA Production Approval 724NM
Limited Type Certificate No. 11 (LTC-11)

L I B R A R Y

MORE INFORMATION
Parts Illustration
Click 'See Document' For Full Information
Technical Order 01-60-107
Technical Order 01-60-113
Click the attatched illustration for proper installation of trim tab hinge spring washer 73-525125
North American Aviation had several Technical Orders  that are not required under the Limited Type Certificate LTC-11. One such order that we always comply with is # 01-60-107, the Reinforcement of the Fuselage rear lower section (tailcone).  Click on the PDF file to the right to review the Technical Order.
Rework of Windshield frame and canopy mechanism
See Document
See Document
See Document
Download
SERVICE
BULLETINS
Service Alert P51-SA-001 Unapproved Parts March 11, 2019:
Mandatory Service Bulletin P51-001 May 1, 2013:

Mandatory Service Bulletin P51-001 and Supplement 1 dated May 1, 2013 is issued by Cal Pacific Airmotive Inc. in cooperation with the National Transportation Safety Board (NTSB) as holder of Limited Type Certificate LTC-11-5 for the P-51B,C,D,K, F-51D and F-51K model aircraft.  It is recommended that all P-51 & TF-51 model aircraft comply with this Service Bulletin, Including those with an experimental airworthiness certificate.

The Limited Type Certificate LTC-11-5 operating Limitations require Air Speed Indicators to be marked in M.P.H., as per aircraft cockpit placards and manuals.  See our FYI page for an example of marking a dual M.P.H. / knots indicator. 

Use good maintenance practices to determine proper application of data from any North American Aviation or USAF Technical Manual for P-51 series aircraft.

 
 
 
North American Aviation Technical Orders required for compliance with Limited Type Certificate TC-11.  Please click the index button at the bottom for a list of additional technical orders, available on request.

Technical Orders are listed numerically from left to right (Note, hard copy in paper bound form is also available - contact us for more information):


Given the post war assembly, rebuild, restoration and interchange of parts on these aircraft, factory compliance of these orders cannot be established. The list of Mandatory Technical Orders are to be complied with by model of aircraft regardless of serial number.
Notes

TO 01-60-JE-8 referenced in Mandatory Service Bulletin P51-001 May 1, 2013


​Technical Order 01-60-100 figure 3 & 4 shims # 122-31105, 122-21040, 122-21041 should  be .063 2024T3 material.